New & established homeowners
Home Maintenance Checklist: Monthly, Seasonal & Yearly Tasks
A practical home maintenance schedule by season, plus monthly and yearly tasks, with a plain note on why each one matters and when to call a pro.
Most of the repairs that hurt start as small jobs nobody mentioned: a gutter that overflowed for three winters, a dryer vent never cleaned, a water heater left alone until it quit. None are hard to prevent. You just have to know they exist and get to them at roughly the right time.
This guide gives you a season-by-season home maintenance checklist, the monthly, quarterly and yearly tasks that don’t belong to any one season, a look at your big-ticket systems, a first-30-days list for new owners, and a simple way to turn it all into a schedule you’ll keep.
A note before you start. The seasons below follow a typical US calendar: spring is March to May, summer June to August, fall September to November, and winter December to February. Climates vary a lot. If your pipes never freeze, skip the winterizing. If you live somewhere hot and humid, your AC deserves more attention than your furnace. Always follow your equipment’s manual over any general list, this one included.
Each item has a short “why” and a hint: DIY (most people can handle it), Pro (hire someone licensed), or Either (it depends on your comfort and your house). For anything involving gas, electrical work, the roof, or anything you’re unsure about, call a licensed professional.
Every month
- Check the HVAC filter; replace or clean it as needed. A clogged filter makes the system work harder and spreads dust. DIY. How often depends on the filter type, pets and the season, so check monthly and change it when it looks dirty.
- Press the test button on smoke and CO alarms. Batteries fail quietly, and you want to find out on a calm Tuesday. DIY.
- Test GFCI outlets (the ones with test and reset buttons, usually near water). Press test, then reset. They protect you from shocks, and most makers recommend monthly testing. DIY. If one won’t trip or reset, call an electrician.
- Test the garage door’s auto-reverse, if you have an opener. Lay a piece of wood flat in the door’s path and close the door; it should reverse on contact. Monthly is ideal, each season at minimum. DIY for the test. If it fails, stop using the opener and call a pro. Never adjust springs or cables yourself; they’re under dangerous tension.
- Run water in unused sinks, tubs and floor drains. It keeps the trap full, which keeps sewer smells out. DIY.
- Clean the garbage disposal. It cuts odors and buildup. DIY.
- Glance at fire extinguisher gauges. The needle should sit in the green. DIY.
- Take a quick leak walk. Look under sinks, around toilet bases, behind the washing machine and near the water heater. A small drip you catch is cheaper than the one you don’t. DIY.
Every quarter
- Check water-softener salt, if you have a softener. DIY.
- Test the sump pump, if you have one, by slowly pouring water into the pit until it switches on. Better to learn it’s stuck before a storm. DIY, but call a plumber if it doesn’t start.
Spring
- Service the AC before the heat arrives. A tune-up catches small problems before your busiest season for cooling. Pro.
- Clean the gutters and downspouts. Overflowing gutters send water toward your foundation. Either: DIY on a single story with a stable ladder; hire out for two stories or steep roofs.
- Look over the roof for winter damage. From the ground, with binoculars, check for missing or lifted shingles and damaged flashing. Pro for anything that means climbing up.
- Check exterior caulk and paint around windows, doors and trim. Gaps let water in behind the siding. DIY.
- Check that soil slopes away from the foundation. Water pooling against the house is a slow, expensive problem. DIY to spot; Pro for regrading.
- Test sprinklers and irrigation. Broken heads waste water and leave dry patches. DIY.
- Reseal the deck or patio if water no longer beads. Sealant keeps wood from soaking up water and rotting. DIY.
- Power-wash siding and walkways. It removes grime and mildew. Either: go gentle on wood and older siding, or hire it out.
- Service the lawn mower. Fresh oil and a sharp blade before the first cut. DIY.
Summer
- Clean the dryer vent, the whole run to the outside and not just the lint trap. Lint buildup is a fire risk and makes every load take longer. Either: DIY for short runs; pro for long or rooftop vents.
- Check attic ventilation and insulation. Look for damp spots, daylight where it shouldn’t be, and signs of pests. DIY to look; Pro to fix. Go early in the day, since attics get dangerously hot in summer, and step only on joists or boards.
- Inspect the deck, fence and outdoor stairs for rot. Soft boards and loose railings are safety issues. DIY.
- Seal pest entry points around pipes, vents and the foundation. Small gaps are an open door. DIY; call a pest pro for an active problem.
- Touch up exterior paint while the weather is warm and dry. Paint is the siding’s raincoat. Either.
- Clean and inspect the grill, including hoses and connections. If you smell gas, stop and get it checked. DIY.
Fall
- Service the furnace or heating system before the first cold night. Pro, especially for gas equipment.
- Clean the gutters again after most of the leaves have dropped. Either.
- Winterize outdoor faucets and irrigation. Shut off and drain hose bibs, and have the sprinkler lines blown out. Water left in the lines can freeze and crack pipes. DIY for faucets; many people hire out the irrigation blowout.
- Check weatherstripping and door sweeps. Drafts waste heat and let in cold. DIY.
- Get the chimney inspected and cleaned if you have a fireplace or wood stove (gas fireplaces and flues need a yearly check too). Creosote buildup in wood-burning chimneys is a fire hazard. Pro.
- Reverse the ceiling fans to run clockwise on low, which nudges warm air back down. DIY.
- Aerate and fertilize the lawn, if that suits your grass type and region. Either.
- Clean and store outdoor furniture and hoses. They last longer out of the weather. DIY.
Winter
- Do a full smoke and CO alarm check. Test every unit, replace batteries as the maker recommends, and check the manufacture date on the back. Alarms don’t last forever, so replace any that have passed the age their manufacturer lists. DIY.
- Watch for ice dams after storms. Ridges of ice at the roof edge can push water under shingles. Pro for removal. Don’t climb an icy roof.
- Protect pipes in hard freezes. Let faucets on exterior walls drip, and open the sink cabinets to let warm air in. DIY.
- Find and seal interior drafts around outlets on exterior walls, the attic hatch and old windows. DIY.
- Vacuum the refrigerator coils. Dusty coils make the fridge work harder. DIY.
- Flush or check the water heater. Draining a bit clears sediment, which helps it run efficiently and last longer. Either: DIY only if your manual covers it; the water comes out scalding hot, so follow the manual’s shut-off steps first. Call a pro for gas units, a dripping relief valve, or if you’re unsure.
Once a year, any time
- Inspect fire extinguishers fully. Once a year, check: gauge in the safe zone, pin and seal intact, no cracks or dents. DIY.
- Recaulk tubs, showers and sinks where the old caulk is cracked or peeling. DIY.
- Find and test your main water shutoff. In a leak you want to know where it is and that it turns. DIY.
- Know where your gas shutoff is, if you have gas. No need to test it. If you smell gas, leave and call the utility from outside. Once gas is shut off, turning it back on and relighting pilots can be a job for the utility or a pro. DIY to locate; Pro for the rest.
- Glance at the electrical panel for rust, scorch marks or a burning smell. Look only, and don’t remove the cover. Pro for anything you find.
- Update your home inventory and review your insurance. If something happens, a current list makes a claim much easier. DIY.
Know your big-ticket systems
A few parts of your house cost thousands to replace. Knowing roughly how old each one is lets you budget before it fails instead of scrambling after.
Find the ages. Check the label or serial number on the water heater, furnace, AC and major appliances; the date is often printed there or encoded in the serial number. Your inspection report may list ages too, and if you’re buying, ask the seller.
Compare against typical lifespans. These are commonly cited ranges, and they vary widely with climate, quality and upkeep:
- Tank water heater: often around 8 to 12 years.
- Furnace: often around 15 to 20 years.
- Central AC: often around 10 to 15 years, sometimes less in hot climates.
- Asphalt shingle roof: often around 20 to 30 years.
- Major appliances: often around 10 to 15 years, some less.
A system near the end of its range won’t fail on cue, but it’s your signal to get a quote, start saving, and ask about it at the next service.
Check the washing machine hoses. Burst rubber supply hoses are a classic cause of floods. Replace rubber hoses every few years, or switch to braided stainless steel. DIY.
Your first 30 days in a new home
If you’ve just moved in, do these first:
- Find the main water and gas shutoffs, and show everyone in the house.
- Label the electrical panel. With a helper, switch breakers off one at a time and note what each controls. Leave the cover on.
- Change or rekey the locks. You don’t know who has keys. Either: DIY or a locksmith.
- Test every smoke and CO alarm and check the manufacture dates.
- Record appliance model numbers for the water heater, HVAC and major appliances, plus any filters they take, like a fridge water filter.
- Find your furnace or HVAC filter size (printed on the filter’s edge) and buy spares.
- Save manuals and warranties in one place; most makers post manuals online.
How to turn the checklist into a schedule that gets done
A checklist tells you what. A schedule tells you when, and that’s the part that usually falls apart.
Give every task a date
“Fall” isn’t a date. Put “Clean gutters” on a specific Saturday in late October and “Service the furnace” on a weekday in early fall. Once a task has a date, it becomes a plan rather than a vague intention. After you finish it, move the date to the next time it’s due.
Keep a monthly home hour
Pick one recurring slot, like the first Saturday morning of the month, and give it 30 minutes. Add it to your own calendar. In that half hour, do the monthly items, look at what’s dated for the coming month, and book any pros you’ll need. HVAC techs, roofers and chimney sweeps get busy at the start of their seasons, so booking early helps.
Keep warranties, manuals and receipts findable
When an appliance acts up, the questions are always the same: How old is it? Is it under warranty? Where’s the manual? For each major appliance and system, note the model and serial number, purchase date, warranty end date, and where the receipt and manual live. Sort that list by warranty date so you can see what’s expiring soon while you can still use it.
Set a simple upkeep budget
Houses cost money even when nothing is broken. Set aside a regular monthly amount for maintenance and repairs, and track what you actually spend. A common rule of thumb is to set aside about 1% to 2% of your home’s value a year for upkeep, more for older homes. After a year or two, your own records will tell you far more about your house than any general formula.
Build a who-to-call list
Find your people before you need them. List your HVAC company, plumber, electrician, roofer and handyman, with each one’s number, what they did, when, and whether you’d hire them again. At 11 p.m. with water on the floor, you’ll be glad the list exists.
Log what you finish
Note the date and anything you noticed (“north gutter sags,” “filter size 16x25x1”). Next year goes faster, and a maintenance history helps if you ever sell.
A Notion template that holds all of this
The Homeowner System is a Notion template that sets all of this up for you. Its seasonal maintenance calendar comes pre-loaded with 35 tasks, each dated for the right season. Alongside it are a warranty, manual and receipt vault with an “expiring soon” list, projects with budgets, home expenses with upkeep totals, a service-provider directory, a room-by-room home inventory for insurance, and a move-in setup checklist.
It works on Notion’s free plan. It won’t send you alerts; it’s a set of organized lists you open during your home hour, so pair it with a recurring calendar reminder for that hour. It’s $29 with a 14-day money-back guarantee, and there’s a free sample on the product page if you’d like to look around first.
FAQ
What maintenance does a house need each year?
At a minimum: a heating service in the fall and a cooling service in the spring, gutter cleaning once or twice, a roof and exterior check, a dryer vent cleaning, and a water heater flush or check. Add monthly filter checks and alarm tests, then adjust for your climate and the systems your house actually has.
How often should I change my HVAC filter?
It depends on the filter type, whether you have pets or allergies, and how hard the system is running. The simplest habit is to check it every month and replace or clean it when it looks dirty. Your filter’s packaging and your system’s manual will give a recommended range.
Which home maintenance tasks should I hire a pro for?
Anything involving gas lines or gas appliances, electrical work beyond resetting a breaker or GFCI, garage door springs and cables, and anything that puts you on a roof. Furnace and AC tune-ups and chimney cleaning are also best left to licensed pros. If a task makes you uneasy, that alone is a good reason to call someone.
Is there a home maintenance schedule template for Notion?
Yes. The Homeowner System is a Notion template with a dated seasonal maintenance calendar, a warranty and receipt vault, and a who-to-call directory. It works on Notion’s free plan, and there’s a free sample if you want to see the layout first.